Quote:
Originally Posted by deezelteck
After dealing with this, I'm thinking races and bearings were installed in a hub that needed replaced. There was plenty of grease, the races would not fit tightly in place. Even after driving in new races the inside would spin, and when the spindle nut was tightened down, there was about an 1/8" of play. I had to back out outer race just so it would tighten up, and get her home. I'm probably looking at a new axle on this one. The spindle got scared pretty bad..
Sent from my SM-N920T using Tapatalk
|
I can see why the spindle got scared! Surprised it wasn't scarred for life by the incident.